Rohde & Schwarz SMU200A - Page 736

Remote Control Commands
R&S
®
SMU200A
716Operating Manual 1007.9845.32 ─ 15
[:SOURce<hw>]:FREQuency:PHASe:CONTinuous:HIGH?
Queries the maximum frequency of the frequency range for phase continuous settings.
The maximum frequency of the frequency range depends on the mode selected with the
command SOURce:FREQuency:PHASe:CONTinuous:MODE.
Return values:
float
0.01Hz
Hz
<High>
Increment:
Default unit:
FREQ:PHAS:CONT:MODE NARR
selects mode narrow.
FREQ:PHAS:CONT:HIGH
queries the max frequency.
Response: 1 003 720 930.23
Example:
Example:
Query only
R&S SMx-B22
Usage:
Options:
[:SOURce<hw>]:FREQuency:PHASe:CONTinuous:LOW?
Queries the minimum frequency of the frequency range for for phase continuous settings.
The minimum frequency of the frequency range depends on the mode selected with the
command SOURce:FREQuency:PHASe:CONTinuous:MODE.
Return values:
float
0.01Hz
Hz
<Low>
Increment:
Default unit:
FREQ:PHAS:CONT:MODE NARR
selects mode narrow.
FREQ:PHAS:CONT:LOW
queries the max frequency.
Response: 998 720 930.20
Example:
Query only
R&S SMx-B22
Usage:
Options:
[:SOURce<hw>]:FREQuency:PHASe:CONTinuous:MODE <Mode>
Selects the mode for determining the frequency range for the phase continuous signal
(see chapter 5.5.3.2, "Phase Continuous Frequency Setting", on page 200).
The minimum and maximum frequency (SOUR:FREQ:PHAS:CONT:HIGH and
SOUR:FREQ:PHAS:CONT:LOW) of the frequency range depends on the mode selected
with this command.
SOURce Subsystem