Remote Control Commands
R&S
®
SMU200A
745Operating Manual 1007.9845.32 ─ 15
[:SOURce]:LFOutput:SWEep[:FREQuency]:SPACing <Spacing>
The command selects linear or logarithmic sweep spacing.
Parameters:
LINear|LOGarithmic
LINear|
<Spacing>
*RST:
LFO:SWE:SPAC LIN
selects linear sweep spacing.
Example:
[:SOURce]:LFOutput:SWEep[:FREQuency]:STEP[:LINear] <Linear>
The command sets the step width for the linear sweep.
This command is linked to the com-
mand :LFOutput:SWEep[:FREQuency]:POINts as follow.
The following applies for STARt < STOP:
POINts = (((STOP-STARt) / STEP:LIN) + 1
If STEP:LIN changes, the value of POINTs is adjusted. The STARt and STOP value is
retained.
Parameters:
float
0 to STOP-STARt
0.1 Hz
Hz
<Linear>
Range:
Increment:
Default unit:
LFO:FREQ:STAR
sets the start frequency to 2 kHz.
LFO:FREQ:STOP
sets the stop frequency to 20 kHz.
LFO:SWE:SPAC LIN
sets linear sweep spacing.
LFO:SWE:STEP 2 kHz
sets the sweep step width to 2 kHz. The number of sweep steps
for linear sweep spacing (POINts) is automatically set to 11.
Example:
SOURce Subsystem
To Next Page
Loading...
