Siemens SINUMERIK 828D Turning - Page 16

Table of contents
Turning
16 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
9 Multi-channel machining (only 840D sl) ................................................................................................. 527
9.1 Multi-channel view (only 840D sl) .............................................................................................
527
9.1.1 Multi-channel view in the "Machine" operating area .................................................................
527
9.1.2 Multi-channel view for large operator panels ............................................................................
530
9.1.3 Setting the multi-channel view ..................................................................................................
531
9.2 Multi-channel support (only 840D sl) ........................................................................................
533
9.2.1 Working with several channels .................................................................................................
533
9.2.2 Creating a multi-channel program.............................................................................................
534
9.2.3 Entering multi-channel data ......................................................................................................
535
9.2.4 Multi-channel functionality for large operator panels ................................................................
539
9.2.5 Editing the multi-channel program ............................................................................................
542
9.2.5.1 Changing the job list..................................................................................................................
542
9.2.5.2 Editing a G code multi-channel program...................................................................................
543
9.2.5.3 Editing a ShopTurn multi-channel program ..............................................................................
546
9.2.5.4 Creating a program block..........................................................................................................
554
9.2.6 Setting the multi-channel function.............................................................................................
556
9.2.7 Synchronizing programs ...........................................................................................................
558
9.2.8 Insert WAIT marks ....................................................................................................................
561
9.2.9 Optimizing the machining time..................................................................................................
562
9.2.10 Simulating machining ................................................................................................................
564
9.2.10.1 Simulation..................................................................................................................................
564
9.2.10.2 Different workpiece views for multi-channel support ................................................................
565
9.2.11 Display/edit the multi-channel functionality in the "Machine" operating area ...........................
566
9.2.11.1 Running-in a program ...............................................................................................................
566
9.2.11.2 Block search and program control ............................................................................................
567
9.2.12 Synchronizing a counterspindle ................................................................................................
569
10 Collision avoidance (only 840D sl).........................................................................................................
575
10.1 Collision monitoring in the machine operator area: ..................................................................
575
10.2 Switching the collision avoidance on and off ............................................................................
576
11 Tool management..................................................................................................................................
579
11.1 Lists for the tool management...................................................................................................
579
11.2 Magazine management.............................................................................................................
580
11.3 Tool types..................................................................................................................................
581
11.4 Tool dimensioning .....................................................................................................................
584
11.5 Tool list......................................................................................................................................
589
11.5.1 Additional data ..........................................................................................................................
593
11.5.2 Creating a new tool ...................................................................................................................
594
11.5.3 Measuring the tool.....................................................................................................................
596
11.5.4 Managing several cutting edges ...............................................................................................
597
11.5.5 Delete tool .................................................................................................................................
597
11.5.6 Loading and unloading tools .....................................................................................................
598
11.5.7 Selecting a magazine................................................................................................................
600
11.5.8 Code carrier connection (only 840D sl).....................................................................................
601
11.5.8.1 Overview ...................................................................................................................................
601
11.6 Tool wear...................................................................................................................................
604
11.6.1 Reactivate tool ..........................................................................................................................
607