Creating a ShopTurn program
7.18 Example: Standard machining
Turning
266 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Set machining area limits No
4. Press the "Accept" softkey.
7. Stock removal (finishing)
1. Press the "Cont. turn." and "Stock removal" softkeys.
The "Stock Removal" input window opens.
2. Enter the following technology parameters:
T Finishing tool_D1 F 0.1 mm/rev V 450 m/min
3. Enter the following parameters:
Machining Finishing (∇∇∇)
Machining direction Longitudinal
Position external
Machining direction
(from front to back)
Allowance No
Relief cuts Yes
Set machining area limits No
4. Press the "Accept" softkey.
8. Groove (roughing)
1. Press the "Turning", "Groove" and "Groove with inclines" softkeys.
The "Groove 1" entry field opens.
2. Enter the following technology parameters:
T Grooving
tool
D1 F 0.150 mm/rev V 220 m/min
3. Enter the following parameters:
Machining Roughing (∇)
Groove position
To Next Page
Loading...
Need help?
General
