Programming technology functions (cycles)
8.1 Drilling
Turning
288 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Parameter Description Unit
(only for
ShopTurn)
Clamp/release spindle
The function must be set up by the machine manufacturer.
Z1 Drilling depth (abs) or drilling depth in relation to Z0 (inc) mm
DT
• Dwell time at final drilling depth in seconds
• Dwell time at final drilling depth in revolutions
s
rev
SPOS Spindle stop position Degrees
Lift mode
• Do not lift off contour
The cutting edge is not fully retracted, but traverses back to the safety clearance in
rapid traverse.
• Lift
The cutting edge is retracted from the hole edge and then moved back to the
retraction plane.
DX (only G Code) Retraction distance in the X direction (incremental) - (for lift-off only) mm
DY (only G code) Retraction distance in the Y direction (incremental) - (for lift-off only) mm
DZ (only G code) Retraction distance in the Z direction (incremental) - (for lift-off only) mm
D (only
ShopTurn)
Retraction distance (incremental) - (for lift only) mm
To Next Page
Loading...
