Siemens SINUMERIK 828D Turning - Page 306

Programming technology functions (cycles)
8.1 Drilling
Turning
306 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Parameter Description Unit
Z0
CP
C0
L0
C1
... C7
L1
... L7
(only for
ShopTurn)
Face C and face Y - polar:
Z coordinate of the reference point (abs)
Positioning angle for machining area (only for face Y)
C coordinate of 1st position (abs)
1. Position of hole with reference to Y axis (abs)
C coordinate for additional positions (abs or inc)
Incremental dimension: The sign is also evaluated.
Distance to position (abs or inc)
Incremental dimension: The sign is also evaluated.
mm
Degrees
Degrees
mm
Degrees
mm
X0
Y0
Z0
Y1
...Y7
Z1
...Z7
(only for
ShopTurn)
Peripheral surface - at right angles:
Cylinder diameter ∅ (abs)
Y coordinate of 1st position (abs)
Z coordinate of 1st position (abs)
Y coordinate for additional positions (abs or inc)
Incremental dimension: The sign is also evaluated.
Z coordinate for additional positions (abs or inc)
Incremental dimension: The sign is also evaluated.
mm
mm
mm
mm
mm
C0
Z0
C1
...C7
Z1
... Z7
(only for
ShopTurn)
Peripheral surface C - cylindrical:
C coordinate of 1st position (abs)
1. Position of hole with reference to Z axis (abs)
C coordinate for additional positions (abs or inc)
Incremental dimension: The sign is also evaluated.
Additional positions in the Z axis (abs or inc)
Incremental dimension: The sign is also evaluated.
Degrees
mm
Degrees
mm
X0
C0
Y0
Z0
Y1
...Y7
Z1
...Z7
(only for
ShopTurn
Peripheral surface Y:
Reference point in X direction (abs)
Positioning angle for machining surface
Y coordinate of 1st position (abs)
Z coordinate of 1st position (abs)
Y coordinate for additional positions (abs or inc)
Incremental dimension: The sign is also evaluated.
Z coordinate for additional positions (abs or inc)
Incremental dimension: The sign is also evaluated.
mm
Degrees
mm
mm
mm
mm