Programming technology functions (cycles)
8.1 Drilling
Turning
310 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Parameter Description Unit
LAB
(only for G code)
Repeat jump label for position
PL
(only for G code)
Machining plane
Circular pattern
Selection option for the following patterns:
• Pitch circle
• Full circle
X0
Y0
α0
α1
R
N
Positioning
(only for G code)
X coordinate of the reference point (abs)
Y coordinate of the reference point (abs)
Starting angle for first position referred to the X axis.
Positive angle: Circle is rotated counterclockwise.
Negative angle: Circle is rotated clockwise.
Advance angle - (for pitch circle only)
Radius
Number of positions
• Straight line: Next position is approached linearly in rapid traverse.
• Circular: Next position is approached along a circular path at the feedrate defined in
the machine data.
mm
mm
Degrees
Degrees
mm
Machining
surface
(only for
ShopTurn)
• Face C
• Face Y
• Peripheral surface C
• Peripheral surface Y
Position
(only for
ShopTurn)
• At the front (face)
• At the rear (face)
• Outside (peripheral surface)
• Inside (peripheral surface)
Position
(only for
ShopTurn)
Selection options for the following positions - (only for face C/Y)
• center
• off-center
To Next Page
Loading...
Need help?
General
