Programming technology functions (cycles)
8.1 Drilling
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
311
Parameter Description Unit
center/
off-center
Z0
X0
Y0
α0
α1
R
N
Positioning
(only for
ShopTurn)
Face C:
Position circle center on the face surface
Position circle off-center on the face surface
Z coordinate of the reference point (abs)
X coordinate of the reference point (abs) – (only for off-center)
Y coordinate of the reference point (abs) – (only for off-center)
Starting angle for first position referred to the X axis.
Positive angle: Circle is rotated counterclockwise.
Negative angle: Circle is rotated clockwise.
Advance angle - (for pitch circle only)
Radius
Number of positions
• Straight line: Next position is approached linearly in rapid traverse.
• Circular: Next position is approached along a circular path at the feedrate defined in
the machine data.
mm
mm
mm
Degrees
Degrees
mm
center/
off-center
Z0
CP
X0 or L0
Y0 or C0
α0
α1
R
N
Positioning
(only for
ShopTurn)
Face Y:
Position circle center on the face surface
Position circle off-center on the face surface
Z coordinate of the reference point (abs)
Positioning angle for machining area
X coordinate of the reference point (abs) or reference point length, polar
– (only for off-center)
Y coordinate of the reference point (abs) or
reference point angle, polar – (only for off-center)
Starting angle for first position referred to the X axis.
Positive angle: Circle is rotated counterclockwise.
Negative angle: Circle is rotated clockwise.
Advance angle - (for pitch circle only)
Radius
Number of positions
• Straight line: Next position is approached linearly in rapid traverse.
• Circular: Next position is approached along a circular path at the feedrate defined in
the machine data.
mm
Degrees
mm
mm
Degrees
Degrees
Degrees
mm
To Next Page
Loading...
