Programming technology functions (cycles)
8.3 Contour turning
Turning
364 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Parameters Description Unit
Uniform cut segmentation
Round cut segmentation at the edge
only for align cut segmentation at the edge:
Constant cutting depth
alternating cutting depth
Allowance Allowance for pre-finishing - (only for ∇∇∇)
• Yes
U1 contour allowance
• No
s
U1 Compensation allowance in X and Z direction (inc) – (only for allowance)
• Positive value: Compensation allowance is kept
• Negative value: Compensation allowance is removed in addition to finishing
allowance
mm
Set machining area
limits
Set machining area limits
• Yes
• No
XA
XB
ZA
ZB
with limited machining area only, yes:
1. Limit XA ∅
2. Limit XB ∅ (abs) or 2nd limit referred to XA (inc)
1. Limit ZA
2. Limit ZB (abs) or 2nd limit referred to ZA (inc)
mm
Relief cuts Machine relief cuts
• Yes
• No
FR Insertion feedrate, relief cuts
* Unit of feedrate as programmed before the cycle call
To Next Page