Programming technology functions (cycles)
8.4 Milling
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
421
Parameters, G code program Parameters, ShopTurn program
PL
Machining plane T Tool name
RP Retraction plane mm D Cutting edge number
SC Safety clearance mm F
Feedrate mm/min
mm/tooth
F Feedrate * S / V
Spindle speed or constant
cutting rate
rpm
m/min
Parameter Description Unit
Machining
surface
(only for
ShopTurn)
• Face C
• Face Y
• Peripheral surface C
• Peripheral surface Y
Position
(only for
ShopTurn)
• At the front (face)
• At the rear (face)
• Outside (peripheral surface)
• Inside (peripheral surface)
(only for
ShopTurn)
Clamp/release spindle (only for end face Y/peripheral surface Y)
The function must be set up by the machine manufacturer.
Reference point
Position of the reference point:
• (lefthand edge)
•
(center)
•
(righthand edge)
Machining
• ∇ (roughing)
• ∇∇ (pre-finishing)
• ∇∇∇ (finishing)
• ∇∇∇ base (base finishing)
• ∇∇∇ edge (edge finishing)
• Chamfering
To Next Page
Loading...
