Siemens SINUMERIK 828D Turning - Page 422

Programming technology functions (cycles)
8.4 Milling
Turning
422 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Parameter Description Unit
Technology
• Vortex milling
The milling cutter performs circular motions along the length of the slot and back
again.
• Plunge cutting
Sequential drilling motion along the tool axis.
Milling direction: - (except plunge cutting).
• Climbing
• Conventional milling
• Climbing-conventional milling
Machining
position
• Single position
Mill a slot at the programmed position (X0, Y0, Z0).
• Position pattern
Mill slots at a programmed position pattern (e.g. full circle or grid).
X0
Y0
Z0
(only for G code)
The positions refer to the reference point:
Reference point X – (only for single position)
Reference point Y – (only for single position)
Reference point Z – (only for single position)
mm
mm
mm
X0 or L0
Y0 or C0
Z0
(only for
ShopTurn)
Face C: The positions refer to the reference point:
Reference point X or reference point length polar – (only for single position)
Reference point Y or reference point angle polar – (only for single position)
Reference point Z – (only for single position)
mm
mm
mm
CP
X0 or L0
Y0 or C0
Z0
(only for
ShopTurn)
Face Y: The positions refer to the reference point:
Positioning angle for machining area – (only single position)
Reference point X or reference point length polar – (only for single position)
Reference point Y or reference point angle polar - (only for single position)
Reference point Z - (only for single position)
Degrees
mm
mm or
degrees
mm
Y0 or C0
Z0
X0
(only for
ShopTurn)
Peripheral surface C: The positions refer to the reference point:
Reference point Y or reference point angle polar - (only for single position)
Reference point Z - (only for single position)
Cylinder diameter ∅ – (only for single position)
mm or
degrees
mm
mm