Programming technology functions (cycles)
8.4 Milling
Turning
434 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
If you do not want to output a count of 1 for the first workpiece, you can specify an
additive value (e.g., <#,$AC_ACTUAL_PARTS + 100>). The workpiece count output is
then incremented by this value (e. g. 101, 102, 103,...).
● Numbers
When outputting number (e. g. measurement results), you can select the output format
(digits either side of the point) of the number to be engraved.
● Text
Instead of entering a fixed text in the engraving text field, you can specify the text to be
engraved via a text variable (e. g., _VAR_TEXT="ABC123").
Mirror writing
You can engrave the text mirrored on the workpiece.
Full circle
If you want to distribute the characters evenly around a full circle, enter the arc angle
α2=360°. The cycle then distributes the characters evenly around the full circle.
Parameters, G code program Parameters, ShopTurn program
PL
Machining plane T Tool name
Milling direction D Cutting edge number
RP Retraction plane mm F
Feedrate mm/min
mm/tooth
SC Safety clearance mm S / V
Spindle speed or constant
cutting rate
rpm
m/min
F Feedrate mm/min
Parameter Description Unit
FZ
(only for G code)
Depth infeed rate *
FZ
(only for
ShopTurn)
Depth infeed rate mm/min
mm/tooth
Machining
surface
(only for
ShopTurn)
• Face C
• Face Y
• Peripheral surface C
• Peripheral surface Y
To Next Page
Loading...
