Programming technology functions (cycles)
8.4 Milling
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
435
Parameter Description Unit
Position
(only for
ShopTurn)
• At the front (face)
• At the rear (face)
• Outside (peripheral surface)
• Inside (peripheral surface)
(only for
ShopTurn)
Clamp/release spindle (only for end face Y/peripheral surface Y)
The function must be set up by the machine manufacturer.
Alignment
• (linear alignment)
•
(curved alignment)
•
(curved alignment)
Reference point
Position of the reference point
•
bottom left
•
bottom center
•
bottom right
•
top left
•
top center
•
top right
•
left-hand edge
•
center
•
right-hand edge
Mirror writing
• Yes
The mirrored text is engraved on the workpiece.
• No
The text is engraved on the workpiece without mirroring.
Engraving text maximum 100 characters
X0 or R
Y0 or α0
Z0
(only for G code)
The positions refer to the reference point:
Reference point X or reference point length polar
Reference point Y or reference point angle polar
Reference point Z
mm
mm or
degrees
mm
X0 or L0
Y0 or C0
Z0
(only ShopTurn)
Face C: The positions refer to the reference point:
Reference point X or reference point length polar
Reference point Y or reference point angle polar
Reference point Z
mm
mm or
degrees
mm
To Next Page
Loading...
