Programming technology functions (cycles)
8.5 Contour milling
Turning
450 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
4. Path milling (finishing)
If you programmed a finishing allowance for roughing, the contour is machined again.
5. Path milling (chamfering)
If you have planned edge breaking, chamfer the workpiece with a special tool.
Path milling on right or left of the contour
A programmed contour can be machined with the cutter radius compensation to the right or
left. You can also select various modes and strategies of approach and retraction from the
contour.
Approach/retraction mode
The tool can approach or retract from the contour along a quadrant, semi-circle or straight
line.
● With a quadrant or semi-circle, you must specify the radius of the cutter center point path.
● With a straight line, you must specify the distance between the cutter outer edge and the
contour starting or end point.
You can also program a mixture of modes, e.g. approach along quadrant, retract along semi-
circle.
Approach/retraction strategy
You can choose between planar approach/retraction and spatial approach/retraction:
● Planar approach:
Approach is first at depth and then in the machining plane.
● Spatial approach:
Approach is at depth and in machining plane simultaneously.
● Retraction is performed in reverse order.
Mixed programming is possible, for example, approach in the machining plane, retract
spatially.
Path milling along center-point path.
A programmed contour can also be machined along the center-point path if the radius
correction was switched-out. In this case, approaching and retraction is only possible along a
straight line or vertical. Vertical approach/retraction can be used for closed contours, for
example.
To Next Page
Loading...
Need help?
General
