Programming technology functions (cycles)
8.5 Contour milling
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
465
Software option
For removing residual stock, you require the option "residual stock detection
and machining".
Clamping the spindle
For ShopTurn, the "Clamp spindle" function can be set up by the machine manufacturer.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
See also
Clamping the spindle (Page 231)
Procedure
1. The part program or ShopTurn program to be processed has been
created and you are in the editor.
2. Press the "Milling", "Contour milling" and "Pocket resid. mat." softkeys.
The "Pocket Res. Mat." input window opens.
3. For the ShopTurn program, press the "All parameters" softkey if you
want to enter additional parameters.
To Next Page
Loading...
