Multi-channel machining (only 840D sl)
9.2 Multi-channel support (only 840D sl)
Turning
536 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Parameter Description Unit
Measurement unit
Selecting the measurement unit mm
inch
Main spindle
Work offset Selecting the work offset
Write to the
work offset
• Yes
Parameter ZV is displayed
• No
Parameter ZV is not displayed
ZV Z value of the work offset
For G54, the Z value is entered into the work offset.
Note:
Please refer to the machine manufacturer's instructions.
Blank
• Tube
• Cylinder
• Polygon
• Centered cuboid
XA Outside diameter ∅ – for tube and cylinder mm
XI Inside diameter (abs) or wall thickness (inc) – only for tube mm
ZA Initial dimension mm
ZI
Final dimension (abs) or final dimension in relation to ZA (inc)
ZB
Machining dimension (abs) or machining dimension in relation to ZA (inc) mm
N Number of edges – only for polygon
SW or L
Width across flats or edge length – only for polygon mm
W Width of the blank - only for centered cuboid mm
L Length of the blank - only for centered cuboid mm
S Speed limitation of the main spindle rev/min
Spindle chuck
data
• Yes
You enter spindle chuck data in the program.
• No
Spindle chuck data are transferred from the setting data.
Note:
Please observe the machine manufacturer’s instructions.
To Next Page
Loading...
