Siemens SINUMERIK 828D - Page 278

Creating a ShopTurn program
8.18 Example: Standard machining
Turning
278 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
5. Stock removal (roughing)
1.
Press the "Cont. turn." and "Stock removal" softkeys.
The "Stock Removal" input window opens.
2.
Enter the following technology parameters:
T Roughing tool 80 D1
F 0.350 mm/rev
V 400 m/min
3.
Enter the following parameters:
Machining
Roughing (∇)
Machining direction
Longitudinal
Position
outside
Machining direction
(from the face to the rear side)
D
4.000
inc
Cutting depth
UX
0.4
inc
UZ
0.2
inc
DI
0
BL
Cylinder
XD
0
inc
ZD
0
inc
Relief cuts
No
Set machining
area limits
No
4.
Press the "Accept" softkey.
If a blank programmed under "CONT_1" is used, under parameter "BL",
the "Contour" blank description should be selected instead of "Cylinder".
When selecting "Cylinder", the workpiece is cut from the solid material.