Siemens SINUMERIK 828D - Page 540

Programming technology functions (cycles)
9.5 Contour milling
Turning
540 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Parameters in the "Input complete" mode
Parameters, G code program
Parameters, ShopTurn program
Input
• Complete
PRG
Name of the program to be generated
T
Tool name
PL
Machining plane D Cutting edge number
Milling direction
• Climbing
• Conventional
milling
F
Feedrate mm/min
mm/tooth
RP Retraction plane mm S / V
Spindle speed or constant cut-
ting rate
rpm
m/min
SC Safety clearance mm
F
Feedrate
mm/min
Parameter
Description
Unit
Machining
surface
(only for ShopTurn)
• Face C
• Face Y
• Face B
• Peripheral surface C
• Peripheral surface Y
(only for ShopTurn)
Clamp/release spindle (only for end face Y/B and peripheral surface Y)
The function must be set up by the machine manufacturer.
Machining
The following machining operations can be selected:
• ∇ (roughing)
• ∇∇∇ base (base finishing)
• ∇∇∇ edge (edge finishing)
• Chamfering
Z0
Reference point in the tool axis Z
mm
Z1
Pocket depth (abs) or depth referred to Z0
mm
CP Positioning angle for machining area
- (only for ShopTurn, machining surface, face Y)
Degrees
C0 Positioning angle for machining surface
- (only for ShopTurn, machining surface, peripheral surface Y)
Degrees
DXY
• Maximum plane infeed
• Maximum plane infeed as a percentage of the milling cutter diameter
mm
%
DZ
Maximum depth infeed
mm
UXY
Finishing allowance, plane
mm
UZ
Finishing allowance, depth
mm