Xerox Phaser 3610

Troubleshooting
Phaser 3610, WorkCentre 3615 Service Manual2-156
FIP 1. 74
017-321 SD CARD Type Invalid Error
Cause:
SD CARD Type Invalid Error was detected.
Solution:
1. Install the SD CARD properly.
2. If the error persists, ensure that the error is replicated after the printer is powered Off and
then On, and then replace the following parts in sequence.
•SD CARD
•(REP 5.1 ESS PWB)
FIP 1. 75
017-600 Address Info Sum Check Fail
Cause:
At Power ON start-up, Check phone book and address book data and initializing incorrect data
automatically.
Solution:
The machine will recover after message is displayed for 3 seconds. (When initialization is not
completed, continue displaying message)
If the error persists, ensure that the error is replicated after the printer is powered Off and then
On, and then replace the following parts in sequence.
•(REP 5.4 Fax PWB)
•(REP 5.1 ESS PWB)