Troubleshooting
Phaser 3610, WorkCentre 3615 Service Manual2-240
FIP 1. 242
035-730 RS Request CS NOT ON
Cause:
In high-speed training, modem CS does not become ON against RS request.
Solution:
The machine will recover after the OK or Close button is pressed or message is displayed for
specified time.
If the error persists:
1. Check the telephone line connection. Reconnect the telephone line connector.
2. Check the sending side fax. Receive the fax data from a good fax machine.
3. Update to the latest F/W.
4. Ensure that the error is replicated after the printer is powered Off and then On, and then
replace the following parts in sequence.
•(REP 5.4 Fax PWB)
•(REP 5.1 ESS PWB)
FIP 1. 243
035-737 CTC/EOR Resend Over
Cause:
CTC/EOR resend over.
Solution:
The machine will recover after the OK or Close button is pressed or message is displayed for
specified time.
If the error persists:
1. Check the telephone line connection. Reconnect the telephone line connector.
2. Check the sending side fax. Receive the fax data from a good fax machine.
3. Update to the latest F/W.
4. Ensure that the error is replicated after the printer is powered Off and then On, and then
replace the following parts in sequence.
•(REP 5.4 Fax PWB)
•(REP 5.1 ESS PWB)