Xerox Phaser 3610

Troubleshooting
Phaser 3610, WorkCentre 3615 Service Manual 2-315
FIP 2.02
IOT Standard Stacker Full
Cause:
Parts to be considered:
• FULL STACK SENSOR (PL 2.5 Exit Chute)
• EXIT SENSOR HARNESS ASSEMBLY (PL 5.4 Electrical Connections)
•MCU PWB (PL 5.3 Electrical (MCU PWB / HVPS))
Solution:
Step Check and Action Yes No
1
• Check the connection between the FULL
STACK SENSOR and the MCU PWB.
• Is the EXIT SENSOR HARNESS ASSEMBLY
(P/J272 - P/J27) connected securely?
Go to Step 2.
Securely connect
the EXIT SENSOR
HARNESS ASSEM-
BLY
2
• Replace the EXIT SENSOR HARNESS
ASSEMBLY.
• Does an error occur?
Go to Step 3.
Troubleshooting
complete.
3
•Replace (REP 2.13 Full Stack Sensor).
• Does an error occur?
Replace
(REP 5.6 MCU
PWB)
Troubleshooting
complete.