Troubleshooting
Phaser 3610, WorkCentre 3615 Service Manual2-226
FIP 1. 214
033-777 FAX RX Decode Input Buffer Over
Cause:
In FAX receive, when copying from ECM buffer to JBIG decode input buffer, input buffer over-
flow.
Solution:
The machine will recover after the OK or Close button is pressed or message is displayed for
specified time.
If the error persists:
1. Check the sending side fax machine or retry sending by lowering the resolution setting.
2. Update to the latest F/W.
3. Ensure that the error is replicated after the printer is powered Off and then On, and then
replace the following parts in sequence.
•(REP 5.4 Fax PWB)
•(REP 5.1 ESS PWB)
FIP 1. 215
033-779 Log File Create Fail
Cause:
Cannot create log file of communication result.
Solution:
The machine will recover after the OK or Close button is pressed or message is displayed for
specified time.
If the error persists:
1. Check the telephone line connection. Reconnect the telephone line connector.
2. Check the sending side fax. Receive the fax data from a good fax machine.
3. Update to the latest F/W.
4. Ensure that the error is replicated after the printer is powered Off and then On, and then
replace the following parts in sequence.
•(REP 5.4 Fax PWB)
•(REP 5.1 ESS PWB)