Xerox Phaser 3610

Specifications
Phaser 3610, WorkCentre 3615 Service Manual 8-5
Electrical Properties
Power Voltage and Frequency
Power Consumption
The following table represents the power consumption of each operation mode under rated input
voltage (110, 127, 220VAC).
Surge Current
When the power switch is turned on, the surge current shall be maximum 50Amp (Cold start)/135Amp
(Hot start) at first 2.5msec, and 80Amp(120V/220V/240V) / 85Amp(100V) within 10msec.
M/C Voltage (V) Frequency (HZ) Input Power (A) Phase
110V M/C
110 to 127V +/-10%
(99 to 140V)
50/60 +/-3HZ
11A or less
(110V system)
Single-phase two-
wire system
220V M/C
220 to 240V +/-10%
(198 to 264V)
50/60 +/-3HZ
6A or less
(220V system)
Single-phase two-
wire system
Operation Mode Power Consumption
Deep Sleep
4.5 Wh/h (Ave) or less (3610)
5.5 Wh/h (Ave) or less (3615)
Sleep
13.5 Wh/h (Ave) or less (3610)
19.5 Wh/h (Ave) or less (3615)
Standby
76 Wh/h (Ave) or less (3610)
82 Wh/h (Ave) or less (3615)
During continuous printing
705 Wh/h (Ave) or less (3610)
750 Wh/h (Ave) or less (3615)
Maximum rated value
1350 W (Max) or less (3610)
1390 W (Max) or less (3615)