Xerox Phaser 3610

Troubleshooting
Phaser 3610, WorkCentre 3615 Service Manual 2-255
FIP 1. 267
050-141 IOT Zone T4 + TR3 Jam
050-141 is displayed in the UI. 074-100 is registered in the Error Log.
Cause:
When Dynamic Jam (cause) was detected:
• 074-100 IOT Tray4 Misfeed Jam
When Static Jam (collateral) was detected:
• Tray4 Path Sensor On
Solution:
1. Paper jam has occurred. Remove the jammed paper.
2. If there is no jammed paper, or the error still occurs after having removed the jammed paper,
turn the power Off and On to check that the error recurs, then proceed to the
FIP 1. 276.
FIP 1. 268
050-142 IOT Remain Zone Regi + MSI + T1 Jam
050-142 is displayed in the UI. 077-106 is registered in the Error Log.
Cause:
When Dynamic Jam (cause) was detected:
• 077-106 Exit On Jam
When Static Jam (collateral) was detected:
•Regi Sensor On
Solution:
1. Paper jam has occurred. Remove the jammed paper.
2. If there is no jammed paper, or the error still occurs after having removed the jammed paper,
turn the power Off and On to check that the error recurs, then proceed to the
FIP 1. 284.