Maintenance
Phaser 3610, WorkCentre 3615 Service Manual6-10
ADJ 4 Adjusting the Density
The Density Adjustment feature controls how much toner is used to print. Adjust the density for lighter
toner use for saving toner or heavier for making prints bolder. A positive adjustment makes the prints
darker, while a negative adjustment makes the prints lighter.You can also adjust it to compensate for
different paper types and thicknesses.
(3610) Procedure
1. At the printer control panel, press the Menu button.
Note: To navigate through the menu, use the Up or Down arrow buttons.
2. Navigate to Admin Settings, then press OK.
3. Navigate to Service Tools, then press OK.
4. Select Adjust Density, then press OK.
5. To increase or decrease the amount of offset, use the arrow buttons, then press OK.
6. To return to the Ready screen, press the Menu button.
(3615) Procedure
1. At the printer control panel, press the Machine Status button.
2. Touch Tool s, then touch Admin Settings.
3. Touch Service Tools.
4. Touch Adjust Density.
5. Touch the desired density from Darken to Lighten, then press OK.
To Next Page
Loading...
