Service Parts Disassembly
Phaser 3610, WorkCentre 3615 Service Manual4-94
REP 4.7 Toner Dispense Motor
PL 3.3 Toner Dispense
WARNING: Allow the Fusing Assembly to cool before servicing the product.
1. Remove the Bypass Tray.
2. Remove the Drum Cartridge.
3. Open the Rear Cover, release the stopper strap and hinge clip from the chassis and rest the Rear
Cover Assembly on the work surface.
4. Remove (REP 1.1 Control Panel (3610)).
5. Remove (REP 1.4 Top Cover Assembly (3610)).
6. Remove (REP 1.6 Right Side Cover (3610)).
7. Prepare the MCU PWB. (Figure 1)
a. Release 3 clips to remove the MCU PWB Cover.
b. Disconnect all MCU PWB connections except P/J11, 18 and 26.
Note: Do not remove the MCU PWB.
Figure 1
s3610-03
P11
P18
P26
To Next Page
Loading...
