Xerox Phaser 3610

Troubleshooting
Phaser 3610, WorkCentre 3615 Service Manual2-260
FIP 1. 274
071-920 Waiting to Print Side 2 Load Printed Pages into the NNN
Cause:
Waiting for side 2 to be set for manual duplex print (Tray).
Solution:
Set the Paper correctly. Press OK button within the specified time.
FIP 1. 275
071-921 Manual Duplex Print
Cause:
Waiting for Set key to be pressed after setting side 2 for manual duplex print (Tray).
Solution:
Set the Paper correctly. Press OK button within the specified time.
FIP 1. 276
072-100 IOT Tray2 Misfeed Jam
073-100 IOT Tray3 Misfeed Jam
074-100 IOT Tray4 Misfeed Jam
Cause:
072-100:
050-139 is displayed in the UI.
After the Tray 2 Feed Clutch turned ON, the Tray 2 Path Sensor did not turn ON within the
specified time.
073-100:
050-140 is displayed in the UI.
After the Tray 3 Feed Clutch turned ON, the Tray 3 Path Sensor did not turn ON within the
specified time.
074-100:
050-141 is displayed in the UI.
After the Tray 4 Feed Clutch turned ON, the Tray 4 Path Sensor did not turn ON within the
specified time.