Troubleshooting
Phaser 3610, WorkCentre 3615 Service Manual 2-235
FIP 1. 232
035-706 Fall Back Error
Cause:
Fall back error.
Solution:
The machine will recover after the OK or Close button is pressed or message is displayed for
specified time.
If the error persists:
1. Check the telephone line connection. Reconnect the telephone line connector.
2. Check the sending side fax. Receive the fax data from a good fax machine.
3. Update to the latest F/W.
4. Ensure that the error is replicated after the printer is powered Off and then On, and then
replace the following parts in sequence.
•(REP 5.4 Fax PWB)
•(REP 5.1 ESS PWB)
FIP 1. 233
035-708 Post Message Resend Over
Cause:
Post message resend over.
Solution:
The machine will recover after the OK or Close button is pressed or message is displayed for
specified time.
If the error persists:
1. Check the telephone line connection. Reconnect the telephone line connector.
2. Check the sending side fax. Receive the fax data from a good fax machine.
3. Update to the latest F/W.
4. Ensure that the error is replicated after the printer is powered Off and then On, and then
replace the following parts in sequence.
•(REP 5.4 Fax PWB)
•(REP 5.1 ESS PWB)