Maintenance
Phaser 3610, WorkCentre 3615 Service Manual 6-11
ADJ 5 Adjusting Altitude
Use Adjust Altitude to adjust the altitude to match that of the location where the printer is installed. If
the altitude setting is incorrect, it can cause print-quality problems.
(3610) Procedure
1. At the printer control panel, press the Menu button.
Note: To navigate through the menu, use the Up or Down arrow buttons.
2. Navigate to Admin Settings, then press OK.
3. Navigate to Service Tools, then press OK.
4. Select Adjust Altitude, then press OK.
5. To select the altitude of the location of the printer, press the arrow buttons, then press OK.
6. To return to Service Tools, press the Back arrow button, or to return to the main menu, press the
Menu button.
(3615) Procedure
1. At the printer control panel, press the Machine Status button.
2. Touch Tool s, then touch Admin Settings.
3. Touch Service Tools.
4. Touch Adjust Altitude.
5. Touch the altitude of the location of the printer, then press OK.
To Next Page
Loading...
