Maintenance
Phaser 3610, WorkCentre 3615 Service Manual6-18
Tag Matrix
Change Tag Introduction
This section describes all of the tags associated with the machine, as well as multinational applicability,
classification codes, and permanent or temporary modification information.
Important modifications to the copier are identified by a tag number which is recorded on a tag
matrix. The tag matrix is on the inside of the Front Cover Assembly.
The Tag information may include:
•Tag
•Class
•Use
• Manufacturing Serial Number
•Purpose
•Name
•Kit Number
•PL Reference.
Classification Codes
A tag number may be required to identify differences between parts that cannot be interchanged, or
differences in diagnostic, repair, installation, or adjustment procedures.
A tag number may also be required to identify the presence of optional hardware, special non-volatile
memory programming, or whether mandatory modifications have been installed. Each tag number is
given a classification code to identify the type of change that the tag has made. The classification
codes and their descriptions are listed in Table 1.
There are no TAGs currently issued for this machine.
Tab le 1 Cl ass if icat io n Cod es
Classification Code Description
USCO Code XE Code
1 Safety
M2 Mandatory tag.
R3Repair tag.
O4 Optional tag.
S4Situational tag
N5 Tag not installed in the field.
6 Refurbishing Only
To Next Page
Loading...
Need help?
General
Weight and Dimensions
