Xerox Phaser 3610

Troubleshooting
Phaser 3610, WorkCentre 3615 Service Manual2-326
FIP 2.13
Registration Clutch Assembly
Cause:
Parts to be considered:
• TAKE AWAY ROLL ASSEMBLY (PL 7.2 Tray 1/Optional Tray 550-Sheet Feeder (2/4))
• REGISTRATION CLUTCH ASSEMBLY (PL 7.2 Tray 1/Optional Tray 550-Sheet Feeder
(2/4))
• OPTIONAL TRAY PWB ASSEMBLY (PL 7.1 Tray 1/Optional Tray 550-Sheet Feeder (1/4))
Solution:
Step Check and Action Yes No
1
Are there any foreign substances in the
REGISTRATION CLUTCH ASSEMBLY Sec-
tion?
Remove the foreign
substances
Go to Step 2.
2
Is the TAKE AWAY ROLL ASSEMBLY
damaged?
Replace the TAKE
AWAY ROLL ASSEMBLY
Go to Step 3.
3
Check the connection between the
Registration Clutch Assembly and the
MCU.
• Is the harness connected securely?
Go to Step 4.
Securely connect
the harness.
4
• Replace the REGISTRATION
CLUTCH ASSEMBLY.
Does an error occur?
Replace MCU.
Troubleshooting
complete.