Xerox Phaser 3610

Service Parts Disassembly
Phaser 3610, WorkCentre 3615 Service Manual4-106
REP 5.5 Front USB PWB
PL 5.2 Electrical (ESS PWB / LVPS) (3615)
Removal
WARNING: Allow the Fusing Assembly to cool before servicing the product.
1. Remove the Bypass Tray.
2. Remove (REP 1.2 Front Cover Assembly (3610 / 3615)).
3. Remove (REP 1.5 Rear Cover Assembly).
4. Remove (REP 1.17 Lower Left Side Cover (3615)).
5. Remove the PWB. (Figure 1)
a. Disconnect P/J2 from the Front USB PWB.
b. Remove 2 screws (silver, tapping, 8mm) to remove the PWB.
Figure 1
Replacement
1. When installing the Front USB PWB, capture the ground wire with the top screw.
2. Replace in reverse order.
P/J15
s3610-18
3
b)
a)