Xerox Phaser 3610

Maintenance
Phaser 3610, WorkCentre 3615 Service Manual 6-7
Adjustments
ADJ 1 Adjusting Paper Type
Use Adjust Paper Type to compensate for paper thickness within a paper type. If the printed image is
too light, use a heavier setting for the paper you are using. If the printed image is mottled or blotchy-
looking, decrease the setting for the paper you are using.
(3610) Procedure
1. At the printer control panel, press the Menu button.
Note: To navigate through the menu, use the Up or Down arrow buttons.
2. Navigate to Admin Settings, then press OK.
3. Navigate to Service Tools, then press OK.
4. Select Adjust Paper Type, then press OK.
5. Select Plain, then press OK.
6. Select Lightweight or Heavyweight, then press OK.
7. To return to Service Tools, press the Back arrow button, or to return to the main menu, press the
Menu button.
(3615) Procedure
1. At the printer control panel, press the Machine Status button.
2. Touch Tool s, then touch Admin Settings.
3. Touch Service Tools.
4. Touch Adjust Paper Type. The default selection for Plain appears.
5. Touch Plain.
6. Touch Lightweight or Heavyweight, then press OK.