Troubleshooting
Phaser 3610, WorkCentre 3615 Service Manual2-242
FIP 1. 246
035-742 ECM Receive EOR-Q Receive
Cause:
IN ECM receive, receive EOR-Q.
Solution:
The machine will recover after the OK or Close button is pressed or message is displayed for
specified time.
If the error persists:
1. Check the telephone line connection. Reconnect the telephone line connector.
2. Check the sending side fax. Receive the fax data from a good fax machine.
3. Update to the latest F/W.
4. Ensure that the error is replicated after the printer is powered Off and then On, and then
replace the following parts in sequence.
•(REP 5.4 Fax PWB)
•(REP 5.1 ESS PWB)
FIP 1. 247
035-746 Before Dial Tone
Cause:
Cannot detect dial tone before dialing.
Solution:
The machine will recover after the OK or Close button is pressed or message is displayed for
specified time.
If the error persists:
1. Check that the telephone line is not busy.Set the a good fax number manually.
2. Update to the latest F/W.
3. Ensure that the error is replicated after the printer is powered Off and then On, and then
replace the following parts in sequence.
•(REP 5.4 Fax PWB)
•(REP 5.1 ESS PWB)