Xerox Phaser 3610

Specifications
Phaser 3610, WorkCentre 3615 Service Manual 8-13
Warm-up Time
The printer shall reach the Ready state within 19.9 seconds after power on.
Warm up time(s) =”FPOT from Power on”(s) -”FPOT from Ready”(s)
FPOT (First Print Output Time)
The table below shows FPOT (First Print Output Time). FPOT is defined as the time from when the
printer driver issues a print request in the Standby mode until when the first printed sheet is output
completely. Process control time is not included.
The job is only set by the previous job and is always kept even after Power-off/on.)
Event Status transition Warm up time Condition
Warm up time
”FPOT from Power on”(s)
-”FPOT from Ready”(s)
19.9 sec or less
22°C/60%RH, Rated voltage.
Recovery from Sleep mode
”FPOT from Sleep
mode”(s) -”FPOT from
Ready”(s)
22°C/60%RH, Rated voltage.
Recovery from Deep Sleep
mode
”FPOT from deep sleep
mode”(s) -” FPOT from
Ready”(s)
Paper Size Paper Type Paper Tray
FPOT
(Ready mode)
A4SEF Plain MSI
6.5 sec. or less
A4SEF Plain Standard Tray (Tray 1)
A4SEF Plain Optional Tray (Tray 2)
A4SEF Plain Optional Tray (Tray 3)
A4SEF Plain Optional Tray (Tray 4)