R5905948 /12 Event Master Devices 15
Revision
Changes
• EC–50 product has been added. Chapters concerned by this new controller have been
modified or added:
- Description in General chapter.
- New chapters dedicated to Controller Orientation, Controller Configuration and
Controller Operation.
• A new version of Event Master Toolset is available (V2.0). The GUI orientation
chapter and the System setup procedure have been updated.
• Two units can be linked. A section in the GUI orientation chapter describes how set
up a linked System.
• A new chapter concerning the maintenance of the S3–4K has been added.
• A new chapter concerning the maintenance of the EC–50 controller has been added.
• Annex:
- New section with S3 specifications.
- Remote command ATRN updated.
- New chapter “THIRD PARTY SOFTWARE ACKNOWLEDGEMENTS” added.
02
• Changes initiated by:
- New software version (V3.0).
- EC-200 product release.
• EC–200 product has been added. Chapters concerned by this new controller have
been modified or added:
- Description in General chapter.
- New chapters dedicated to Controller Orientation, Controller Configuration and
Controller Operation.
• The Front Panel Menu orientation chapter has been updated:
- a modification in the front menu panel of the "Event Master Processor" to take into
account a configuration created offline and transferred via USB device.
• A new version of Event Master Toolset is available (V3.0). The GUI orientation
chapter has been partially updated. A more complete update of this chapter will be
performed at the next version of the document.
- Win 10 has been added in the list of Operating Systems that accepts the "Event
Master Toolset" Software.
- A new section describes the Controller menu.
• A new chapter concerning the maintenance of the EC–200 controller has been added.
• Annex:
- New short section with EC-50 specifications.
03
• Changes initiated by:
• Updated RoHS table, taking into account the March 2016 changes.
04
• Changes initiated by new software version (V4.1).
- “Complete” vs “Relative” Preset configuration, see “Programming Menu >
Adjustment area > Presets configuration”, page 235.
- Destination Groups, see “Programming Menu > Adjustment area > Dest Group
configuration”, page 228.
- Firmware upgrade for EC-200, see “EC-200/EC-210 Firmware Upgrade”, page 360
and “Settings Menu > Web App area > Tools > Manage Software”, page 264.
- Added “Backgrounds as Inputs.” Refer to “Programming Menu > Resources area”,
page 198, and see the “Backgrounds as Inputs” subsection., and see the
“Backgrounds as Inputs” subsection.
- Linking Event Master units, see “Configuration Menu > Linking”, page 178.
- Added MVR slot configuration. Refer to “Configuration Menu > Adjustment > Unit
Configuration”, page 118, and see the Description of the Setup tab..
- Updates to Output configuration and Destination configuration; refer to
“Configuration Menu > Adjustment > Output Configuration”, page 136 and
“Configuration Menu > Adjustment > Destination Configuration”, page 145.
- Preset Conflict Mode: Off, see “Configuration Menu > System modifier area”, page
115.
Introduction