R5905948 /12 Event Master Devices 363
Once on PVW only the clear button in the GUI or on the right side of the controller will remove the layer from
PVW.
12.6 What are Layer executers?
General
These are the buttons to the right of the Layer Buttons, the function of them is described in context above and
in detail below.
Freeze PGM
Button Freezes program of selected Layer(s) of the selected destination(s), blue LED when active.
Press again to release freeze.
Freeze PVW
Button freezes preview of selected Layer(s) of the selected destination, blue LED when active.
Press again to release freeze.
Arm
Button arms key-frame effects on selected layers in all selected destinations.
Indication of armed FX on PGM, red LED.
Indication of armed FX on PVW, green LED.
Match PGM
Match the selected layer in Preview to its corresponding layer in Program.
Button matches the function of Match Program in the GUI.
Blinks red when pressed.
Can be used across multiple layers and destinations.
Layer Trans
Transitions Selected Layers into Program, at a rate based on the # of frames set for the layer in the GUI.
Button matches the function of Trans in the GUI below the workspace.
Layer Cut
Cut selected layer into Program.
Button matches the function of CUT in the GUI below the workspace.
12.7 How to use assign buttons
General
The Assign buttons are rows of 12 user-mappable buttons that allow for quick recall of a memory or resource.
Each row can be selected independently to several function (bus) types.
Currently available assignment are:
Source (Yellow)
Places the mapped source into the selected layer(s) or AUX.
User Key (Magenta)
Recalls the mapped User Key to the selected layer.
Preset (White)
Recalls the mapped Preset to the whole Preview.
Cues (Cyan)
Controller Operation
To Next Page
Loading...
Need help?
General
