Barco Event Master E2 Series User Manual

R5905948 /12 Event Master Devices458
15.10 Front Panel Knob
Flow chart
Image 15-18
Before you proceed removing the Front panel knob you need to remove the Front Cover Assembly
as outlined in the related procedure.
Necessary tools
• Knob removal tool provided by Barco
Image 15-19
• Flat head screwdriver or a tool with a sharp edge
How to remove the Front Panel Knob
1. Remove the knob cover with a flat screw driver or a sharp object to expose the inside of the knob.
Image 15-20
2. Use the knob removal tool provided by Barco to take out the knob. Align the notches on the tool with the
grooves in the knob as indicated below.
Note: If the tool is not available use fine point needle nose pliers to squeeze at knob between the two
grooves while pulling it out.
S3 Maintenance

Barco Event Master E2 Series Specifications

General

Brand	Barco
Model	Event Master E2 Series
Category	DJ Equipment
Language	English