R5905948 /12 Event Master Devices278
Restore a system configuration file
Use the following steps to restore your system from the USB Drive:
1. Insert a FAT32-formatted flash drive in the unit’s front-panel USB port.
2. From the System menu, scroll to the USB Backup/Restore submenu. Select Restore Config.
The USB Restore Config submenu appears.
3. Press SEL and scroll through the list of configuration files. When you locate the file you want, press SEL
again.
A message confirms the restore operation and instructs you to reboot the Event Master series processor.
You must reboot the system to use the restored configuration file.
At the conclusion of this procedure, your system is completely set up — exactly the way that you left
it when you performed a complete system “backup.” No further setup operations are required.
7.7 User preference setup
General
This procedure enables you to set a variety of important user preferences and options.
Prerequisite
• Ensure that you are familiar with the Black Invalid menu. For details on this menu, please refer to chapter
“System menu > Black Invalid”, page 89.
• Ensure that you are familiar with the VFD brightness menu. For details on this menu, please refer to
chapter “System menu > VFD brightness (display brightness)”, page 94.
Set a variety of important user preferences
Use the following steps to set user preferences:
1. Select System from the Setup menu.
2. Select Black Invalid from the System menu to set Black on Invalid Video on or off.
3. Select VFD brightness from the System menu to adjust the intensity of the front panel vacuum fluorescent
display (VFD) screen, from 1 (dim) to 6 (bright).
7.8 Saving the setup
General
In this procedure, you will save all system setup parameters to non-volatile memory.
Prerequisite
• Ensure that you are familiar with the Save All function. For details on this menu, please refer to chapter
“Save All”, page 100.
Save all system setup parameters
Use the following steps to save all system setup parameters:
1. Select Save All from the Setup menu.
2. Wait a few seconds. When the parameters are saved you are returned to the Setup menu.
System Setup
To Next Page
Loading...
Need help?
General
