Barco Event Master E2 Series User Manual

R5905948 /12 Event Master Devices 381
No. Maintenance action Remarks
1 Check battery valid date. If the date is older than 4 years,
replace battery as a preventative
measure.
See Image 16-15 for the location
of the system battery.
Note: When a new battery is
installed, the user needs to place
a sticker with the date on the
motherboard mount that indicates
when the battery was last
replaced. The absence of sticker
means the battery has never
been replaced. In this case the S/
N sticker can be used for the
reference date.
13.4 EC-30 maintenance actions
No preventive action is needed on this device.
13.5 EC-50 maintenance actions
No preventive action is needed on this device.
13.6 EC-200/EC-210 maintenance actions
MAINTENANCE TYPE C (perform every year)
The yearly maintenance actions, listed below, may be performed by the user in accordance with the
procedures described in the EC-200/EC-210 Maintenance chapter*.
No. Maintenance action Remarks
1 Check battery valid date. If the date is older than 4 years,
replace battery as a preventative
measure.
Note: When a new battery is
installed, the user need to place a
sticker with the date in the unit
(on the rear of the chassis, near
the Motherboard) that indicates
when the battery was last
replaced. The absence of sticker
means the battery has never
been replaced. In this case the S/
N sticker can be used for the
reference date.
2 Remove dust accumulation Remove dust accumulation from
the CPU fan on the motherboard
with a few short bursts of
compressed air.
Preventive maintenance actions

Barco Event Master E2 Series Specifications

General

Brand	Barco
Model	Event Master E2 Series
Category	DJ Equipment
Language	English