R5905948 /12 Event Master Devices354
Connection diagrams
Image 11-3: EC-200 connections
Image 11-4: EC-210 connections
Description
Connect the network outlet 1 to your Event Master Device Network for static IP address and outlet 2 for a
DHCP assigned IP address. Plug the cord to the power outlet. Necessary cables (except a network cable) are
provided in a new system. In the case that the original cables are missing, simply use standard computer
cabling to make these connections.
The 4 USB connectors in the back can be used for keyboard and mouse and other supported USB devices.
The USB connector in the middle of the top of the console is to be used with the USB flash drive that ships
with the controller.
11.5 Touchscreen calibration
General
This feature depends on the controller type:
EC-50
The EC-50 requires a host computer. Calibration of the touchscreen could be necessary when your
touchscreen responds imprecisely.
EC-200/EC-210
The EC-200/EC-210 has 2 integrated capacitive touchscreens that do not require calibration. If they don’t
behave properly there can be dirt between the surface of the screen and the cover.
Controller Configuration
To Next Page
Loading...
Need help?
General
