R5905948 /12 Event Master Devices 221
Image 6-86
Once the two keyframes are defined, the PIP can move between the two positions by pressing the green
arrow buttons. The rate for the movement is adjusted by changing the number in the corresponding box.
Any of the two keyframes can be deleted when the keyframe is highlighted and by pressing the “Delete KF”
button.
The red LED in the keyframe button indicates the current position of the PIP.
Layer adjustment panel > Main adjustment
The Main adjustment panel is variable according the Layer type.
Layer type = PIP (Border Tab):
This menu allows users to adjust the PIP borders.
• Borders are enabled by selecting the type to apply.
Six choices are available:
- Off
- Hard
- Soft
- Halo
- Halo-in
- Halo-out
• Border width and color are selected by adjusting
the corresponding sliders or entering a figure in
the adjacent edit boxes. The border width can be
entered either in Percentage of the vertical size or
in pixels.
• The selected color is shown in the Current Color
bar. The color can also be stored by clicking in one
of the square boxes at the bottom of the menu
next to the Learn button. These boxes are quick
shortcuts to select that color for the Border.
• Another way to specify a color is to click on the
Color wheel. The slider values will change
accordingly as the mouse moves around the color
wheel.
• Learn: The “Learn” button in the bottom is a way
to store custom colors to be used for later. The
way to use this area is to:
a) Pick a color to save, using color wheel or the
R/G/B adjustments.
b) Click Learn button.
c) Click any one of the buttons on the right.
d) The color that was picked is now stored in this
button.
Layer type = PIP (Shadow Tab):
The Shadow Menu enables the user to place a shadow behind a PIP.
EM GUI orientation
To Next Page
Loading...