EasyManuals Logo

Barco Event Master E2 Series User Manual

Barco Event Master E2 Series
584 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #45 background imageLoading...
Page #45 background image
R5905948 /12 Event Master Devices 45
Unpacking
At delivery, Event Master devices are packed in a shipping case. Place the shipping case of the device on a
stable (solid), flat and insulated support during all the unpacking. Open the case from the top. Remove the
device that is packaged in an antistatic bag. Check the box content after unpacking.
After unpacking let the device acclimate to the room temperature which must be higher than 0°C
(32°F) and lower than 40°C (104°F) (lower than 35°C (95°F) for EC-200/EC-210). Neglecting this
may result in startup failure of the device.
Save the original shipping case and packing material, these will be necessary if you ever have to
ship your device. For maximum protection, repack your device as it was originally packed at the
factory.
When shipping an E2 in a Barco-supplied case, make sure that the rear connector protectors are
installed to prevent damage.
Box content
After unpacking an Event Master device, it is recommended that it be checked to see if all accessories were
included.
Depending on the product, the following accessories should be included.
Product Contains Accessories included
R9009203
(E2 Gen 2)
• 4RU–V2 rack mount
chassis
• E2 Gen 2 assembly
• 2x 14-9750004-90 • European Power Cord CEE7 (not included with units shipped to
China)
• 2x B1959864 • US Power Cord NEMA 5/15 (not included with units shipped to
China)
• 2x B1959865 • China Power Cord GB 2099 (included only with units shipped to
China)
• 2x B1959860 • CXP Expansion Link Cables
• 2x 09-0106032-91 • Rear Rack Mount Support Plates
• 8x 13-0081012-90 • 8-32 x .38 Pan Head Screws for Rear Rack Mount Support
Plates
• 2x 09-0106031-90 • Rear Rack Mount Brackets
• 07-1205500-00 • USB Thumb Drive (Contains Users Guide, System Software and
Control GUI)
• R5905947 • Safety manual
• 26-1803004-00 • Quick Start Guide
R9004799
(E2)
• 4RU rack mount
chassis
• E2 assembly
• 2x 14-9750004-90 • European Power Cord CEE7 (not included with units shipped to
China)
• 2x B1959864 • US Power Cord NEMA 5/15 (not included with units shipped to
China)
• 2x B1959865 • China Power Cord GB 2099 (included only with units shipped to
China)
• 2x B1959860 • CXP Expansion Link Cables
General

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Barco Event Master E2 Series and is the answer not in the manual?

Barco Event Master E2 Series Specifications

General IconGeneral
BrandBarco
ModelEvent Master E2 Series
CategoryDJ Equipment
LanguageEnglish

Related product manuals