R5905948 /12 Event Master Devices506
Spare Part Kit Description
R9004745 DVI Output
R9004758 VPU card
R9004765 Quad DP 1.2 Output Board
R9004785 Tri-Combo Input
R9004786 Tri-Combo Output
R9004791 Quad HDMI Input
R9004792 Quad HDMI 2.0 Output
R9004793 Quad DP 1.2 Input
Necessary tools
None.
How to remove a card
1. Locate the card that you wish to replace.
2. Loosen the left and right thumbscrews that hold the card in the chassis.
3. Grasp the thumbscrews, and gently pull the card out of the slot.
You may need to wobble the card a bit to loosen it from the mating connector as you pull it out.
Image 16-5: EX chassis: with Event Master cards removed
1 Card from slot #1
2 Card from slot #2
3 Card thumbscrews
How to install a card
To install an Event Master input or output card, follow the steps of the removal procedure in reverse order.
Apply a little pressure on the card, until it is fully inserted in the back plane connector. At this point
the sheet metal of the card should contact the sheet metal of the chassis.
EX Maintenance
To Next Page
Loading...
Need help?
General
