Making and receiving calls
Manpack Transceiver 2110 series Reference Manual 205
Replacing LQA information as part of a call in an ALE/CALM network
To replace LQA information as part of a call:
1 Press SCAN to stop scanning.
1 Start the call using your preferred method.
For example, go to the Address List then select the entry for the station you want to
call.
1 When the transceiver prompts you to select a channel/mode, select <auto>, then
hold CALL.
1 View the LQA screen for the best channel/mode to use.
1 Press CALL to continue the call.
1 When prompted again to select a channel/mode, you can:
• Press to select the best channel/mode combination determined during the
Channel Test call.
• Select any other channel that had an acceptable LQA score.
• Select <auto> for the transceiver to select the best channel/mode for the call,
starting with the channel on which the most recent successful link was
established.
1 Press CALL to continue the call.
Making a Channel Test call in an ALE/CALM network
To make a Channel Test call in an ALE/CALM network:
1 Press CALL.
1 Type the ALE NET or Group Selective address syntax of the stations for which you
want to replace the LQA information, then select Channel Test? as the call type.
1 Select the ALE/CALM network in which you want to make the call.
The LQA screen displays the best channel for the network, including the LQA score
as a percentage, and the BER/SINAD scores at the local and remote stations.
NOTE
You do not have to select a network if you are sending the call to a
NET address as the network is already defined by the NET.
To Next Page
Loading...
