Operating the transceiver from a computer
Manpack Transceiver 2110 series Reference Manual 433
scan command
Use the scan command to:
• display the current scanning state of the transceiver (if scanning is on, the name of
the network being scanned is also displayed)
• control whether scanning is on or off
• specify the network to be scanned
Syntax
scan
scan on
scan off
scan <network>
where:
scan displays the current scanning state of the transceiver, that is, whether scanning is
on or off.
on starts scanning all networks that are set to scan.
off stops scanning and enables channels to be changed manually.
<network> switches to the specified network and starts scanning that network.
Compatibility with CICS V2
In CICS V2, scan tables are used instead of networks. The scan tables are named with
single numeric characters. To maintain compatibility with CICS V2 or less, networks
must be named with single numeric characters.
NOTE
Issuing a scan on command when a lock is on automatically unlocks
the interface (see page 427, lock command).
To Next Page
Loading...
