Controlling user access
Manpack Transceiver 2110 series Reference Manual 469
Syntax for the Message 10 entry
The following rules apply to configuration commands used in the Message 10 entry in
the Control List:
• All commands are case-sensitive.
• Commands must begin with the characters #$! followed by a space, for example,
#$! BSP. If you do not use these characters, the transceiver reads any characters in
the entry as a standard message.
• Category commands must be followed by a hyphen, then the specific commands,
separated by commas. Each category and corresponding commands are separated by
a space, for example:
#$! LM-FV,UL BCT-M,GP FTCD SOS
Activating configuration commands in the Message 10
entry
After entering a configuration command in the Message 10 entry, you must switch your
transceiver off then on again to activate the command.
The transceiver automatically locks and hides the Message 10 entry if the text in the
entry begins with #$!.
NOTE
These configuration commands operate at the user level. If you are logged
in to admin level you have full access to the above functions, regardless of
the setting in the Message 10 entry.
NOTE
If you remove a configuration command from the Message 10 entry under
admin login, you should also unlock and show the Message 10 entry, if
required.
To Next Page
Loading...
Need help?
General
