Using lists
128 Manpack Transceiver 2110 series Reference Manual
Logging in to admin level
Logging in to admin level gives you access to the Admin... group of entries in the List
Manager (see Table 19 on page 108). These entries enable you to lock and hide
information at admin level.
When you log in to admin level:
• all locked entries are temporarily unlocked
• full view is enabled
There are two ways you can log in to admin level. If you are prompted to enter a
password when you switch on the transceiver, you can enter the admin password instead
of the user password.
You can also log in to admin level by logging in at user level then using the Admin login
entry in the List Manager.
Logging in to admin level from user level
To log in to admin level from user level:
1 Hold to open the List Manager.
If Quick Start is enabled, scroll to Advanced... in the Quick Start menu, then
press .
1 Scroll to Config..., then press .
1 Scroll to Admin login, then press .
1 Enter the admin password, then press .
You are logged in to admin level and the List Manager remains open.
1 If you want to access the Main Menu, press until Main Menu is displayed.
NOTE
If you want to log in to admin level this way, make sure that a user and an
admin password have been set in the Control List. When you switch on
the transceiver, you are only prompted to enter a password if a user
password is set.
NOTE
If an admin password has not been set in the Password Admin entry
in the Control List, you can log in by simply pressing .