Operating the transceiver
84 Manpack Transceiver 2110 series Reference Manual
Scanning channels
If you intend to receive calls on several channel/modes, switch on scanning. When
scanning is switched on, the transceiver selects each channel/mode in your network in
quick succession to detect incoming calls. The channel/modes are scanned in a
continuous cycle. Mute is switched on automatically. For more information on setting up
a network to be scanned see page 144, Scan Network.
When the transceiver detects a call addressed to your station, it stops scanning and
notifies you according to the type of call received (see page 219, Receiving a call). When
you press SCAN to end the call, scanning resumes. If you do not press this key to end
the call, or any other key within a pre-determined timeout, the transceiver automatically
ends the call and resumes scanning (see page 250, Auto Resume entries).
When the transceiver detects voice, it notifies you according to the mute setting selected
(see page 83, Muting the transceiver). If your transceiver is set to notify you when voice
is detected, you can pause scanning, select the channel/mode on which the voice was
heard, then resume scanning when required.
It is recommended that scanning is switched on when you are not using the transceiver to
communicate.
Switching scanning on or off
To switch scanning on or off:
1 Press SCAN.
If a call is not in progress, scanning is toggled on or off.
If a call is in progress, the call is ended and the transceiver begins scanning.
NOTE
When scanning is switched on, mute is also switched on.
If you press PTT while the transceiver is scanning, the scan is paused.
To Next Page
Loading...
Need help?
General
