Operating the transceiver from a computer
424 Manpack Transceiver 2110 series Reference Manual
gpsbeacon command
Use the gpsbeacon command to request the current GPS position of another station.
Syntax
gpsbeacon <address of called station>[@<network>] [from <self
address>[@<network>]]
where:
<address of called station>[@<network>] is the address [and network] of
the station from which you want to receive a GPS position.
from <self address>[@<network>] is the self address [and network] you want
to use for this call.
NOTE
You can use the gpsbeacon command if Option GPS Enable is
installed.
NOTE
The transceiver of the receiving station must have Option GPS Enable
installed. If it has not been installed or GPS data is unavailable, a message
is displayed to inform you of this.
NOTE
You cannot use the ALL, ANY, Group Selective, NET, or Wildcard
address syntax with a gpsbeacon command due to collision of
responses.
NOTE
For more information on:
• address syntaxes see page 406, Addresses in commands
• call options see page 407, ALE call options
• recognised variables see page 408, Recognised variable expansion
To Next Page
Loading...
Need help?
General
